We run fall tune-ups for heating, spring tune-ups for cooling, and full-system checks whenever a home changes hands or a system has been ignored for a few years. Timing counts here: a September visit is calm and thorough, while the same check in late October, after the first hard cold rolls off the foothills, turns into a triage call.
Call (970) 555-0134 to book a tune-up before the season rush.
What a furnace tune-up includes
- Heat exchanger inspection: visual and camera check for cracks and rust, the single most important safety item on the list.
- Combustion and carbon monoxide testing: measured, not guessed, with readings adjusted for Loveland's altitude.
- Ignition system check: ignitor resistance and condition, flame sensor cleaned and tested.
- Burner inspection and cleaning: burners pulled and cleaned if the flame pattern shows they need it.
- Blower check: motor amperage, wheel condition, and a temperature-rise reading to confirm airflow is in the manufacturer's range.
- Condensate system: drain flushed, trap checked, and freeze risk noted on high-efficiency models.
- Safety controls: limit switches, pressure switches, and rollout switches verified.
- Filter and thermostat: filter replaced or flagged, thermostat settings and batteries confirmed.
What an AC tune-up includes
- Coil cleaning: outdoor condenser coil washed out, indoor evaporator coil inspected.
- Refrigerant check: pressures and superheat or subcool readings compared against the system's specs. Low readings mean we hunt for the leak instead of topping off and hoping.
- Electrical testing: capacitor measured under load, contactor contacts inspected, compressor amperage recorded.
- Condensate drain: flushed, with the safety switch tested. This one prevents the most common summer water-damage call we see.
- Full cycle test: the system runs through a complete cooling cycle while we watch temperatures at the vents.
Signs your system is overdue for a tune-up
- Nobody can remember the last time a technician opened the unit
- The furnace or AC runs longer than it used to for the same comfort
- Bills creep up year over year with no rate change to blame
- The system has gotten louder: more rumble, more whistle, more startup clunks
- You are buying a home and want to know what you actually own
- The equipment is past ten years old and has never had a documented inspection
HVAC Tune-Up in Loveland homes
Timing matters here. Loveland's first hard cold usually arrives off the foothills with little warning in October, and every heating company in the Thompson Valley books out within days of it. Fall tune-ups done in September are calm, thorough appointments. The same visit in late October is a triage call.
Altitude shapes the checklist. At 4,982 feet, combustion readings and gas pressures need to be evaluated against derated values, and a furnace tuned by sea-level numbers will run sooty and inefficient all winter. We also pay extra attention to condensate routing on Loveland's many high-efficiency furnaces — the 2013-flood-era replacements are now old enough that drain lines sag, traps dry out, and freeze damage shows up in unheated crawlspaces around Lake Loveland and the older parts of town.
Summer tune-ups have a local enemy too: cottonwood fluff. A condenser cleaned in May can be matted over by late June along the river, so we note coil condition and show you how to rinse it safely between visits.
What a tune-up costs
Most Loveland homeowners pay between $89 and $189 for a single-system tune-up visit, with the range set by system type and how much cleaning the equipment needs. A tune-up is not a repair — if we find a failed or unsafe part, we quote it separately and the decision is yours. Plenty of people pair the visit with an HVAC Maintenance Plan so the next one is already scheduled; if the check turns up real trouble, Furnace Repair or AC Repair is the next step.
Call (970) 555-0134 to schedule an HVAC tune-up in Loveland, CO.